360 Screw

Description

A cutaway system is available on this glove

A HandyCam glove that will hold any camera or device that is secured with a standard 1/4″-20 UNC screw – to mount 360 cameras, SLR’s, etc.

The screw is accessible through the base of the glove with the glove off, and the screw is captive within the glove, so that it doesn’t get lost! It has a flip out wing on it to enable doing it up by hand, but it is recommended to use a screw driving to finally tighten it to ensure your camera stays where you want it. As always, though, never do the screw up too tight – it is possible to pull and mount out of the base of a camera!

Sizing

Small 20cm (7 3/4 inches) around the knuckles, 9cm (3 1/2 inches) knuckles to wrist

Medium 23cm (9 inches) around the knuckles, 10cm (4 inches) knuckles to wrist

Large 25cm (10 inches) around the knuckles, 11cm (4 1/4 inches) knuckles to wrist

X-Large 28cm (11 inches) around the knuckles, 11cm (4 1.4 inches) knuckles to wrist

Measure around your knuckles with your fist clenched. Custom sizes are also available. As the gloves are fully adjustable, most sizes fit most hands – if you wear gloves most of the time, measure with your gloves on – it will still fit your bare hand, I guarantee it!